Side Rabbet Plane Pair

Price: $225.00
Product ID : 1-98-99

Purchase

E-mail to a friend | Add To Wish List

Details

Side Rabbet Plane Pair

Based on the Stanley No. 98 and 99, our Side Rabbet Planes are the perfect answer to trimming and widening rabbets, dadoes, and all kinds of hard-to-reach recesses and corners. Superbly crafted in Bronze with polished Cherry knobs. The low angle A2 blades produce excellent cuts on both end and long grain. Adjustable depth stops control depth and help steady the tool to the work. The front shoe can be reversed to create a bullnose or removed completely to allow access into tight corners.

Rather than combining two blades in one tool, we offer a matched pair, one left and one right, so you can choose the one best suited to grain direction and type of cut.

  • 4-1/2" long x 2" high, will fit into a 3/16" groove at full depth.
  • Width of cut is 1/2".
  • Weight is .50 lbs. each.

Use

Side Rabbet Plane Pair

This pair of side rabbet, or fillister, planes is perfect for cleaning up or widening dadoes, rabbets, tenons and sliding dovetails. Width (depth) of cut is 1/2". These tools will fit into a 3/16" groove at full depth. Body is 4-1/2" long x 2” high. A shoe in front of the blade can be removed to allow the tool to reach right into the corners of your work.

Geometry:

The blade is bedded at 8° with a 25° bevel, for an included cutting angle of 33°.

Shoe:

The brass shoe installed in front of the blade may be reversed to allow planing to within 3/16" of the end of a groove, or removed entirely.

Blade Adjustment:

Adjust the blade by hand. Loosen the cap screw, then sight along the sole for depth of cut, and to make sure the edge is parallel to the sole.

Blade Sharpening:

The blades are ready to cut wood out of the box. They are ground sharp at a 25° bevel. You may wish to give them a light honing before use. A secondary bevel helps achieve a razor edge.

Maintain the 25° bevel, or adjust as needed for harder woods. The skew angle is 30°. The blade can be honed freehand, or you can build a jig to hold the blade while using a stone in your hand to sharpen it.

Note: As you sharpen the blade, you will have to restore the relief angle to allow the blade to plane to the bottom of a groove.

Tool Care

Materials:

We use Manganese Bronze for our tool bodies. These castings are fully stress relieved, a process that removes inherent stresses and ensures that the tool will remain flat and true. The blade is A-2 Tool Steel, cryogenically treated and double tempered to Rockwell 60-62. Our heat treating technique ensures that the blade will take and hold a very fine edge for a long time. After heat treating, the blade is fully surface ground on the top, back, and cutting edge, giving a smooth, flat surface that will take a mirror finish very quickly. The 1/8" thickness provides solid chatter-free cutting.

Maintenance:

The Bronze bodies are hand lapped flat. Depending on how much use your tool gets, an occasional light sanding with 320 or finer wet/dry paper on a flat surface will keep the sole in as-new condition. Many people like the patina that Bronze gets with age and use, but if you wish to keep the finish bright a little brass polish is in order.

Guarantee:

Materials and workmanship are guaranteed for the life of your tool. Call for repairs or replacement parts. We are available for advice if you ever have a problem using your tool.

Proposition 65 Notice:

Bronze and brass alloys contain lead, a chemical known to the State of California to cause cancer and birth defects, or other reproductive harm. Wash hands after handling.